ZTwentyAteU
03-03-2006, 03:49 AM
Alright guys, I peeled off my HVAC and Lightswitch gauges and scanned them. If you don't have a scanner, I have posted them at the bottom of this so you don't have to. I have not changed the size, so once you are done messing with them, print and they will be the exact size. This is for 97-up cars
Install instructions:
HVAC-
-Print off your new white/or whatever you made gauge, cut it out with scissors and cut out the 4 holes with a razorblade, try to cut straight as possible. If you don't, it will be ok, your knobs will cover the cut.
-I recommend printing it on photo or sticker paper, but regular paper will do. I also recommend laminating it or putting a piece of clear box tape over it to protect from coke spills/splashes/etc.
-Take off the radio/vent bezel, it pulls straight off
-Take off the knobs, they come straight off with a little muscle
-Now SLOWLY peel off the overlay, try not to break it
-If you do it right, there should still be sticky glue on there, which will hold the new one in place if you are not using sticker paper.
-Now stick your new gauge on the HVAC control, lining it up with the edges and making sure the knob holes are lined up also
-Now you are done..put the knobs and bezel back on, sit back and admire your handywork
Light Control
-its the same as the HVAC, just pull the vent bezel off and peel your stock gauge off, an intall the new one
Don't worry, it will still light up, but the light will shine around the icons intead of through them.
http://www.660rebelz.com/hvac.jpg
http://www.660rebelz.com/lights.jpg
Install instructions:
HVAC-
-Print off your new white/or whatever you made gauge, cut it out with scissors and cut out the 4 holes with a razorblade, try to cut straight as possible. If you don't, it will be ok, your knobs will cover the cut.
-I recommend printing it on photo or sticker paper, but regular paper will do. I also recommend laminating it or putting a piece of clear box tape over it to protect from coke spills/splashes/etc.
-Take off the radio/vent bezel, it pulls straight off
-Take off the knobs, they come straight off with a little muscle
-Now SLOWLY peel off the overlay, try not to break it
-If you do it right, there should still be sticky glue on there, which will hold the new one in place if you are not using sticker paper.
-Now stick your new gauge on the HVAC control, lining it up with the edges and making sure the knob holes are lined up also
-Now you are done..put the knobs and bezel back on, sit back and admire your handywork
Light Control
-its the same as the HVAC, just pull the vent bezel off and peel your stock gauge off, an intall the new one
Don't worry, it will still light up, but the light will shine around the icons intead of through them.
http://www.660rebelz.com/hvac.jpg
http://www.660rebelz.com/lights.jpg