- i need major help
- lt1 turning over hard but won;t start
- Is this a good deal or no?
- alternatives to the lt4 manifold?
- O2 sensor
- antifreeze question
- How bad is green coolant for me?
- Starting Problems...Really ****ing Mad
- shipping question
- major issues
- 396 stroker,procedure?
- Next step
- Coil plug shot out today:confused:
- Which cam?
- Push Rods..help real quick.
- low coolant light
- vibration at high rpms
- i need some specs
- spark plugs and ignition wires ???
- Self aligning of non?
- Alum Vette heads vs Stock lt1 heads.
- Car giving me trouble still. AHHHH!
- Weird issues with starting car
- Electric Waterpump
- Car just dies
- what does a lt4 instake go for?
- Cam take out????
- does this look right?
- Roller Rockers
- temp reading
- 503 cam...Fanta, enter please..
- Which rockers to go with?
- Pushrod guideplate HELL...
- Heads
- coolant temp help!!
- overheating after waterpump and ECT replacement
- Leaking Water Pump
- Transmission Mount Question
- Changing and Opti Spark.... New to Forum
- Engine Light: P1441/P0441
- Chipping for bolt ons?
- Mass Air Flow Sensor
- rtv sealent
- cam selection
- what heads with the hot cam kit?
- Cloyes double roller
- Edelbrock heads
- Bent push rod, worn guideplate, photos attached...Need help quick
- Gm847
- 5500 rpm miss
- Piston Slap???
- cam packages
- 396+afr heads,got some questions?
- Starting motor
- radiator overflow cap and light
- 2500 rpm ignition hesitation??
- top end ticking
- Po443
- oil leak and oil light
- Head Gaskets..Resurfaced??
- Car kills while driving
- getting ready to pull motor
- This weekend no more oil leak wooootttttt!!!!!
- HELP!!! Dipstick Tube...
- Many people may not know this....
- Hard Start
- pushrods: come in
- Oil Pressure On Old Motor?
- Can stock rods hold???
- Amperage caused backfires...
- ASR cable adjustment, how?
- 1.6 rr question's....
- what is this?
- 1977or 78 corvette engine QUESTION!!! help
- underdrive pullies?
- Tune for fuel pressure?
- new motor rebuild how long break in period
- 160 stat....
- Fuel pressure - Help here plz
- Threw all these codes!!!
- car hesitant again
- TONS of problems???
- Shoebox, or who ever else can help!!
- how hard is it to remove oil pan?
- flywheel interference
- Oil Pressure Sensor
- has it been done, would it work?
- should i buy this?396 fully built
- For all thoes who need to know
- SES Light (AIR Pump problems)
- Rear Main Seal Conversion.
- roller rocker question???
- How do I get my balancer off?
- Quick oil question
- WTB: 1.6 roller rockers/what brand?
- 94's come with hardened pushrods?
- my engine value
- I think my fuel pump is gone, as well as my intake gasket.
- Possible Trans Problem?
- Won't Run
- Cam or Performance Package
- Have No Spark Please Help
- could bad 02's be it?
- Misfire- help
- Need Help Fast
- Gm water pump or Electric Pump
- Over heating 94
- best oil weight
- vented vs unvented opti
- too good of a deal or what?
- Still have bad mpg
- What is the sensor on the driver side valve cover?
- blaster coil part number...
- Rough Idle - Could I Have A Cam
- Rear main.
- Hesitation at Startup
- Water Pump replacement.
- Overheating problem.
- Coolant problem! Please help
- opti location
- car died on highway
- a few questions...need alittle info
- i need help NOW
- Crank Pulley Alignment
- so im going to build a stroker!!
- Kentucky area
- How much fuel pressure ?
- torque converter
- header leak cause backfires?
- Do I have an underdrive crank pulley?
- motor swap
- New engine?
- What oil To use
- Just replaced Opti, quick question
- which is stronger lt1, ls1?
- Spark Plugs?
- Corvette LT-1 dress up plates
- Another Problem
- changing to stynthetic?
- Fire coming out of my tail pipes
- backfire right at 3 grand?
- Head Question?
- coolant issues
- So I'm a complete car newbie.
- O2 Replacement
- engine
- Engine Build
- are madz28 tunes good?
- timing chain question
- cloyes double roller
- 1995 Impala SS A/C Compressor into my z28?
- Engine stumble?
- Heads
- Coolant
- cam info 101??
- problem with tall valve covers
- rebuilt motor any more hp
- tempature kit
- what opti to get?
- lt4 conversion"?
- fuel system
- awd dyno vs 2wd
- Need cam help
- Thermostat??? 160 or 180?
- Can it be true??
- Am i getting a code?
- Help Identifying an air induction part
- Radiator fuild
- Signs of opti going out?
- Fuel Pump or Leaky Injectors????
- need info of this cam,306
- Rough Idle / boggin down / No Power
- rough idle when hot
- I got my new parts!
- long starts, backfire and smoke
- Backfiring/Missing/Something or other......
- Waterpump & Opti replacement
- spark plug wire help
- missing again!!!
- We consitiantly ran 14.60's!!!
- Ignition tech
- Headers vs. Cam
- opinions on solid roller vs hydraulic roller
- Rpm's on forged internals
- 1.6 roller rockers
- Next performance step...
- 94 Z Bone Stock Valve Diameter Sizes ??
- list of lt1's et's??
- LT1 to LS1 Conversion
- Somethig wrong?!?!
- Coolant temp sensor
- throttle response
- HELP! Car Wont start
- How many horses?
- speculations on setup please
- 5000 backfire help
- TB bypass
- changing oil pan gasket and rear main seal?
- Disconnecting the AC
- Some questions
- Head Gasket
- Cam combo?
- How should i do my car?
- 1640 and where to find list
- Low compression for procharging?
- Doughnut city
- Seafoam question pls help
- simple question
- procharger 12-20 psi???
- Question on roller rockers?!?!
- Check Engine Light
- Trickflow heads???
- Which radiator for 1994 Z-28?
- Backfire, Slippage?
- Distributor
- a strange problem
- going from lt1 to ls1
- What Lifters, Pushrods should I Use
- Degree Retard Problem???
- head?
- What will I run?
- Rebuild Cost
- lt4 or le2?
- This ever happen?
- Thunk thunk thunk :(
- What Parts Should I Get
- Fuel leak on top of engine
- RaceTronix Pump
- Le2 Heads and Cam
- Unusual Idle
- what lifters with hot cam kit?
- ATI or Fluidampr?
- Big block possible in a 4th gen?
- Really high idle
- whats this box..ANYONE KNOW???
- solid roller cam/valve train
- Carteck heads???
- Cost of 383 stroker
- Switch to synthetic?
- 1997
- Still Searching
- Hose name
- Code 16 Help
- 30# SVO's
- Electric water pump failure...??
- beware of elitesparkplugs.com
- need help with custom cam
- Tach Just Isnt Working...
- 1.5 or 1.6 rockers???
- spark plugs and plug wires?