09-18-2009, 04:18 PM
|
|||
|
|||
|
Will Not Start
I have a 96Z and the car has been sitting for awhile. I have chrged the battery to a full charge and the car will crank over great ,but it will not start ? There are no codes or SES light on . Where are some areas to start to look and as much detail as possible . Thanks
|
|
09-18-2009, 05:08 PM
|
||||
|
||||
|
The first thing that you need to do is figure out if it's fuel, or spark that is not working. Rent a pressure tester from autozone and check the pressure. And, pull the wire off the coil and crank it over, it should throw a long spark around the coil. Then, pull a wire off the plug and check for spark there.
__________________
1996 Z28, OBD-I Conversion, SLP CAI, Hooker Super Comp Headers, Custom ORY, Custom Exhaust, 3.73's, It's Slow... For everyone asking about Gear RPO codes, here they are... Gu2 : Axle rear, 2.73 ratio, gu4 : Axle rear, 3.08 ratio, gu5 : Axle rear, 3.23 ratio, gu6 : Axle rear, 3.42 ratio Quote:
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
