07-03-2008, 12:35 PM
|
|||
|
|||
|
T.V. Cable
Ok.... I Have A 700R4 tranny that i got rebuilt, still a good torque converter, and finally hooked up my t.v. aka shift-down cable.... but it's slipping through 2nd and 3rd and red lined at 5500 into 4th.. Should i disconnect my t.v and adjust it with the screw threads on the upper end up or down? It's on a 1987 z28 w/ a 305 TPI. Everything's stock...
|
|
07-03-2008, 01:57 PM
|
|||
|
|||
|
TV Cable = RG-58 lol
__________________
'99 Camaro z28 M6 Rear Mount T67, FMIC, 317 Heads, EPP FI Cam, 60lbs Injectors, Walbro 255 Pump, LS7 Lifters, Patriot Dual Gold Springs, MT ET Streets, BMR SFC, BMR Springs, AGX KYB Struts
560rwhp/589rwtq @ 10psi + Meth
|
|
07-03-2008, 11:39 PM
|
|||
|
|||
|
t.v. cable=Throttle Valve
|
|
07-04-2008, 12:03 AM
|
||||
|
||||
|
are you sure the routing of the cable hasnt changed making it shorter that what ya need?
kinda hard to say without being able to see it.
__________________
2010 Victory Red Camaro SS/RS LS3/M6 Car #227 1996 Z28 ( 357 ci LT1 with a few goodies) 2008 Silverado LT ( 5.3L Flexfuel) 2007 Trailblazer LT ( 4.2L v6) 
|
|
07-12-2008, 02:08 PM
|
|||
|
|||
|
No, it's about a quarter inch play on both sides of the wire on the top side.... which is what their supposed to have on the top side the transmission guy did the bottom one and bolted it on there before i ever put it in....
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
