08-31-2003, 07:09 PM
|
|||
|
|||
28x10.5x15 ET Drag
Would a 28x10.5x15 ET Drag work ok on my car?
I have a SS3800 converter and can not get traction with 275x50x15 BFG DRs and was looking at getting ET Drags. Come Christmas I will be getting 3.73 gears but I am only running 3.23s right now. I was wanting to get the 28s not the 26s, because I was told the 28s will pick up my mph. I am pulling low 1.8 60's right now, but I am doing everything I can to keep the a$$ to the ground.
__________________
Drive it like you stole it! 
|
|
09-01-2003, 12:06 AM
|
||||
|
||||
|
i've seen people run very well on BFG DR's it could be either bad track prep, or ur not doing a burnout long enough, or the tire pressure is too high...any one of those can cause a DR to act like if not worse than a normal street tire
__________________
99 Z 6 spd, Hooker Longtube Headers, hooker offroad Y pipe, cut out, flowbastard( not in use), whisper lid, K&N filter, 85mm MAF, 228/230 .578/.597 112LSA, Patriot stage II 243 heads w/ ferrea valves, com cams hardened pushrods, ls6 intake, NGK plugs, Magnecor 8.5 wires, Free mods, Ram air, built T-56, Star Spec stgIII clutch w/ lightweight flywheel,McLeod Adjustable Master CYlinder, upgraded Slave cylinder, pro 5.0 shifter, short shifter handle, Chrome ZO6 rims,315/35/17 DRs, 4.56 rear
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drag radials | ssdreamz | Z Lounge | 32 | 06-22-2006 03:33 PM |
| Who makes the best drag radials??? | screaminchev93 | Misc. Tech Support | 9 | 11-25-2003 06:09 PM |
| drag bags | zeek racing | Drivetrain | 0 | 08-03-2003 01:14 PM |
| Good Drag Radials? | metalhead_z28 | Misc. Tech Support | 8 | 05-19-2003 09:10 AM |
Linear Mode
