|
|||||||
| Mobile Electronics Car Audio, TV,DVD, GPS Navigation, Radar Detectors, etc.. |
![]() |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
strange problem...
sups? i am trying to replace my factory radio in my camaro...it still has the monsoon factory one. well i got a gm adapter so i can just hook that to the harness from the car and wire my new radio to that. also te antennea adapter and mounting kit. anyways, when i turn my new radio on it only stays on for 5 or 10 seconds then it shuts off. any ideas why??? also there is another plug that was in the back on my old radio that has nothing to go to now, what is it for? the factory amp? any help, much appreciated
|
|
|||
|
i have the bose system and i had the same problem when i turned my cd player on, but my radio worked. there is a power ant. and a cont. power wire. hook the power ant. from the deck to the cont. power on the harness. it might be the other way around, i cant remeber exactly but that is the problem.
__________________
95 Camaro Z28: Ram Air Scoop, CAI, 52mm TB, Shaved heads, 3 angle valve job, LT4 springs, LT Hooker headers, Pacesetter Y pipe, cut outs, 3" Flowmaster Exhaust, 3.73 gears, Turbo 350 tranny, Hypertech programer, Under Drive Pulleys, 100 Shot NX Nitrous wet kit 2006 Best time on NOS- 12.37@111 2007 Best Time on Motor-12.66 @104 |
|
|||
|
hey man thanks alot, this problem has been driving me crazy... i will try it asap...also do you have 2 plugs in the back of your factory radio? the one the adapter harness plugs into that has the power, speaker, etc. wires and then another one that is like a black connector with like a red tab or sumthing on it that has no wires marked but they are like black and green if my memory serves me right?
|
|
|||
|
i cant remember, it has been about 6 months since i looked.
__________________
95 Camaro Z28: Ram Air Scoop, CAI, 52mm TB, Shaved heads, 3 angle valve job, LT4 springs, LT Hooker headers, Pacesetter Y pipe, cut outs, 3" Flowmaster Exhaust, 3.73 gears, Turbo 350 tranny, Hypertech programer, Under Drive Pulleys, 100 Shot NX Nitrous wet kit 2006 Best time on NOS- 12.37@111 2007 Best Time on Motor-12.66 @104 |
|
|||
|
it is hard to find if i remember correctly it should be under the computer and to get to it from the inside is very hard. i believe there is something running threw the middle of it. was that the problem with your deck?
__________________
95 Camaro Z28: Ram Air Scoop, CAI, 52mm TB, Shaved heads, 3 angle valve job, LT4 springs, LT Hooker headers, Pacesetter Y pipe, cut outs, 3" Flowmaster Exhaust, 3.73 gears, Turbo 350 tranny, Hypertech programer, Under Drive Pulleys, 100 Shot NX Nitrous wet kit 2006 Best time on NOS- 12.37@111 2007 Best Time on Motor-12.66 @104 |
|
|||
|
well i gave up on putting my aftermarket deck in but its no problem i still got the monsoon in there so its all good...and yes i did run into the problem of my amp not tunrning on so your solution worked, thanks. also after searching and searching i found where the hole in the firewall is, so now all i gotta do is mount my amp and i'm all set, thanks again
|
|
|||
|
car audio answers
As far as putting an aftermarket deck in shouldn't be a problem. If you have a voltage tester that would test for continuity and to test to see which wires are give a 12V reading you can just connect to back of deck. What year camaro do you have and do you have the stock woofer in the rear with door and side panel speakers stock as well.
|
![]() |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Possible Trans Problem? | Xtreme98Z28 | Engine Tech | 2 | 07-02-2006 01:19 PM |
| tranny or torque converter problem? | Mean Green | Drivetrain | 2 | 07-01-2006 02:08 PM |
| High Oil Pressure Problem | gsxrblue | Engine Tech | 3 | 09-09-2003 12:09 PM |
| Charging system problem. | steve | Ignition/Electrical | 0 | 01-24-2003 09:30 AM |
| T56 Reverse gear problem | Z281996 | Drivetrain | 1 | 01-21-2003 09:51 PM |