|
|
|||||||
| News & Announcements Your news and annoucnement source |
 |
|
|
LinkBack | Thread Tools | Display Modes |
11-07-2009, 07:39 PM
|
||||
|
||||
|
First time on the dyno!
293whp and 330ft/lbs!
So im sorry if this is not where dyno numbers should be but I couldnt find the thread with dyno numbers, and we are closing up here at work some im putting this up really quick. So I have a 94 Z M6 with basically an intake and catback.. 293whp and 330ft/lbs.. I was really hoping for the 300 mark i guess i will get it next time. Hopefully once the new LPP headers get made.. bolt a set of those with the y-pipe and a good tune and be somewhere around 330hp sound practical? im also throwing codes and my a/f ratio is around 15-16 at idle... 10's through the mid and towards the end its in the 12's..
__________________
It's not bragging if you can back it up. 
|
|
11-07-2009, 08:41 PM
|
||||
|
||||
|
Yah, I bet you could work on the fuel some
 For your mods, those are pretty good numbers ... definitely would be excited about it. 320-330 sounds reasonable after the headers.
__________________
"Think with your dipstick, Jimmy!" Click SIGPIC to go to Paulster2.com!  Paul J. - Cam Swap Cam Selection LT1 Cam Specs Cam Write-up Pinion angle help Head Flow Seafoam Howto Injector worksheet LT1 INFO Aftermarket Links 2009 HRPT
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
